Problem: Leaky Concrete Walls

The foundation of your home can become brittle and weak over time. As this happens, it may start to crumble in areas creating cracks and openings for water to leak inside. The damaged concrete can be found anywhere along your foundation. Any moisture that seeps inside will likely run down the wall creating a visible stain. Water will also collect in pools on the floor near the cove joint (where the wall meets the floor). If you notice leaks or broken sections of concrete in your foundation, contact a professional ASAP before the damage gets worse and leads to additional problems.

Solutions:

SafeBasements™ Waterproofing System

basement waterproofing before after

To repair the leaks in your basement, we can install a SafeBasements™ waterproofing system. Our system will prevent future moisture accumulation underneath your home, minimizing potential damage to your walls, floors, or any valuable belongings you may store there. We strive to we offer the most advanced waterproofing system on the market today.

The Safe Edge™ System

safe edge

Click The Image To View PDF

Our advanced system provides a deeper profile allowing it to cover more surface area than other traditional systems on the market. The increased surface area allows for more water to be directed to a sump pump in faster time than with an alternative system. It features built-in multi-flow drain tile, a sump pump with a clear lid, and battery backup systems are also available for installation. It has a rubber seal that diverts water away from the cove joint and into the drain tile, and then out through the sump pump.

Safe Drain™ Waterproofing System

safe drain

Click The Image To View PDF

This system features a low profile, wide design allowing for adequate floor thickness to be poured over it after installation. The wider design allows for better water flow while reducing hydrostatic pressure.

Installation involves the following steps:

  1. Existing concrete is removed around the perimeter of the basement.
  2. We clean the footing area, removing soil and gravel.
  3. We drill weep holes into the block cells and mortar joints.
  4. Then we install the system on top of the exposed footing.
  5. Once installed, we attach the system to the sump pump.
  6. Then we restore the concrete we removed earlier.

Safe Track™ Water Evacuation System

Safe Track™ Water Evacuation System

Click The Image To View PDF

Our water evacuation system can be installed without excavating the soil around your home or basement floor. Typically, this system is installed in homes with monolithic floors. Thanks to the easy set up, there is no damage caused to your foundation during the installation of this product.

Installation involves the following steps:

  1. The concrete surface adjacent to the perimeter block is scarified.
  2. Weep holes are drilled into the block cells and mortar joints.
  3. The floor is cleaned with fresh water a few times.
  4. The drain is attached to the sump pump.
  5. Two-part epoxy is installed and the system is put into position.
  6. Epoxy is cleaned and the track is left to cure.
  7. The system is flood tested for any leaks.

Reviews

Average rating for Safe Basements of North Dakota is 4.94 stars of 5 stars - based on 16 reviews
5
Basement Waterproofing in Jamestown, ND

Installed interior drain in our basement.